From Optflux
Jump to: navigation, search

OptFlux allows the user to perform a simulation of a mutant strain, i.e. of the model with some genetic modifications, in this case a set of gene or reaction deletions.

Access the "Knockout" option either through the "Simulation" menu or right clicking on the model icon in the clipboard.
Mutantmenu.png
In this menu you wil have two options: "Gene" and "Reaction".

Selecting Reaction will allow the selection of the reactions directly.

CobraReactionKO1.png

If the COBRA for OptFlux is installed new Simulation Methods will be available in this operation:

  • Cobra FBA
  • Cobra GeometricFBA
  • Cobra LMOMA
  • Cobra MOMA


You can simulate a mutant in OptFlux followign the steps:

1.Select Project
Choose the Project to do the simulation.

2.Select Genes/Reactions to delete
Choose the gene/reactions as shown above.

3.Objective Function Configuration
In the objective function section, you have select a reaction (typically the biomass/ growth reaction, selected by default) to maximize or minimize the corresponding flux.

4.Select the simulation method
Select between the simulation methods available.

5.Select Environmental Conditions
If you have created environmental conditions you can select them to be used as constraints in the optimization. These can be used to define the values of drain fluxes, i.e. the rates at which metabolites are consumed or produced.

And that's all!! You can press OK and after MATLAB perform the simulation the results will be loaded into the clipboard.


CobraRKOResult1.png